by Bill Andreas | Sep 16, 2022 | FAQ ADAS Tools
Sensor Replacement / Accident Repair / Wheel Alignment / Windshield Replacement / Diagnostic Service
by Bill Andreas | Sep 16, 2022 | FAQ ADAS Tools
During the Pre-SCAN procedure, the MaxiSys software will scan all modules in all systems and list on a single screen, then provide visual ADAS icons next to the active ADAS modules. This shows technicians which ADAS systems are active and helps prepare a more detailed...
by Bill Andreas | Sep 16, 2022 | FAQ ADAS Tools
The technician can review the post-calibration scan to confirm if the module DTC is cleared. The ADAS module calibration will not complete if the calibration steps were not followed correctly.
by Bill Andreas | Sep 16, 2022 | FAQ ADAS Tools
Depending on vehicle type, either a Stationary or Dynamic calibration procedure is required (in some vehicle types both are required) to calibrate ADAS sensors to vehicle modules. • Stationary calibrations are completed in a shop environment and requires the use of...
by Bill Andreas | Sep 16, 2022 | FAQ ADAS Tools
• Flat and level surface with enough room around the vehicle to complete calibration procedures. (generally, there should not be objects within the 15 foot by 30 foot calibration area) • Perform calibration procedures indoors without object obstructions. • No exterior...
